Gel Polish 190
|
Applying the gel polish:
Step 1 - Fluff the nail with a buffer
Step 2 - Use Easy Off Prep to prepare the natural nail
Step 3 - Apply a thin base coat with Base / Gloss gel varnish or the Flexi Builder family with one of the
steps Step 4 - Apply in a UV lamp (4x9W) for 2 minutes or in an LED lamp for 20 seconds
Step 5 - Apply a layer of the selected gel lacquer color
Step 6- Apply in aUV lamp (4x9W) for 2 minutes or in an LED lamp for 20 seconds
7. Step 8 - Apply a second coat of
paint Step 8 - Cure for 2 minutes in a UV lamp (4x9W) or 20 seconds in an LED lamp
Step 9 - cover the nail Base / Gloss gel varnish with a thin layer or any Mystic Nails flexible fényzselével
Step 10 - bond 2 min UV lamp (4x9W) or LED lamp for 20 seconds at
step 11. - If Base / Gloss gel lacquer cover in optionally fixed with the nail gel Cleanser fixative
removal of the gel varnish:
step 1 - very finely grated the gel varnish surface, facilitating easier impregnation of the detaching fluid
step 2 - wet a detaching film batt prerecorded Remover in
Step 3 - Place the embedded part of the release liner on the nail, then wrap the aluminum foil around the ends of the fingers to secure it
. about natural nails. Carefully remove any gel polish left on the nail surface with an orange stick .
Typically in summer, due to high UV exposure due to increasing solar radiation and “soaking” in chlorinated (pool) or salt (sea) water, certain gel polish colors may fade during wear and may change color. Mystic Nails gel polishes are premium quality products with highly pigmented colors that, however, can be sensitive to the above environmental influences to some degree.
1. step – clean the natural nails with Acetone Free Polish Remover
2. step – gently file the natural nails surface with a block buffer
3. step – put a small amount of Easy Off Prep on the nail and let it dry
4. step – apply a thin layer of ColorMe! Base/Gloss gel-lack
5. step – cure for 2 minutes in UV light or 50 seconds in LED
6. step – apply a thin layer of the chosen color of ColorMe! gel-lack
7. step - cure for 2 minutes in UV light or 50 seconds in LED
8. step – if needed apply a second layer of the chosen color of ColorMe! gel-lack
9. step - cure for 2 minutes in UV light or 50 seconds in LED
10. step – cover the nail with ColorMe! Base/Gloss as a top layer
11. step - cure for 2 minutes in UV light or 50 seconds in LED
12. step – Remove tacky residue with Gel Cleanser
Removal of ColorMe!
1. step – very gently file the surface of the gel-lack as it will help the remover liquid to be absorbed better
2. step – soak the cotton pad attached in the foil wrap with ColorMe! Remover
3. step – put the cotton pad on the nail and wrap the foil around the finger to fix it
4. step – remove the foil after 15 minutes which will already pull down the most of the gel-lack. In case some gel-lack remains carefully remove with the help of an orangewood stick.